|
开发板固化程序到NAND FLASH
* i% A* ^" Q; h加载和运行烧写程序nand-writer.out出现NAND flashing failed!错误
! D' `+ w9 h5 G6 W, |6 ]9 O1 R% O3 E$ B0 k# p- }* v9 _
[ARM9_0] Starting DA8xx_NANDWriter.
& {. G' B9 i8 Y. o6 _( |- `DA8XX/OMAP-L1XX part detected. Its an ARM boot device
k5 q) q* |. M2 [ You require two images to boot this device3 ]: o" s; y* P3 j( ~/ u5 Z
1) ARM UBL in AIS file format.* X+ v4 u& [8 y" f7 _$ a6 K
2) U-Boot image in raw binary format
* z. c' S# Z4 HTo generate the AIS format file, you need to run the ARM/DSP .out (COFF) file generated from CCS build through the AISGen tool.
" H C0 _+ [; J9 C% O: G ERROR: NAND Initialization failed.% X: G: [3 Y/ k- y K1 K
: L+ ]+ D* p+ i
- U b) G, C, ?! \2 {* Y4 M, s) E1 H$ Z0 s& @% x( ]
NAND flashing failed!3 t2 ?3 |, C$ l$ w' |! M
(设置从UART2启动), ?% X* g+ X' ^- j
( x; O& Z1 z, K- r; y) N |
|