|
开发板固化程序到NAND FLASH3 P6 E- Q) E: g" i R& A
9 q* k6 G0 W& \' n+ s* C加载和运行烧写程序nand-writer.out出现NAND flashing failed!错误3 [; t3 c1 w$ q- ~
! @1 R) \$ Y5 w& _; j! y6 c( Q$ Q/ w; S! D1 X( Z k" t& b
[ARM9_0] Starting DA8xx_NANDWriter.& V: @# V/ ~6 F& c; m2 q, k
J. \- Q+ @/ C0 \' l) [, TDA8XX/OMAP-L1XX part detected. Its an ARM boot device3 A) u; y( k+ q* k3 r3 } H/ @% D
You require two images to boot this device- } Q% x: x3 v" V- ^% {" Y# q. L# Q9 A7 D ~" r* q
1) ARM UBL in AIS file format.
- D+ y ?8 l. e+ x 2) U-Boot image in raw binary format! N3 Q: K1 }5 r j6 ?3 F
: D& i3 @( a/ X5 `, h4 ? k% GTo generate the AIS format file, you need to run the ARM/DSP .out (COFF) file generated from CCS build through the AISGen tool., f1 x* Q7 P2 C7 Y) e; U" g
ERROR: NAND Initialization failed.! H4 G4 l5 s6 B0 Y
+ H8 k, U; z4 s3 G7 c; M; ~
/ W/ g2 Z1 F. O% \+ f: o) \) X* h+ x' _ ?8 {- ]% B$ w8 z1 m2 p* H, [3 C; o/ G, d/ V
4 p$ B* ]' i2 L$ `+ X. H
, L& A) u2 W) |* ?2 i: JNAND flashing failed!$ u/ R8 `5 k# a. a/ i+ P" H5 ?
(设置从UART2启动)2 d. x7 z- X% P7 g; a$ j* U6 k2 i
这个该怎么解决呢?
4 V0 V& s0 ?- E" f |
|